« previous next »
Pages: [1]   Go Down

Author Topic: Stratus/Revit/Ductmate Frames  (Read 645 times)

0 Members and 1 Guest are viewing this topic.

Offline JgarciaTopic starter

  • Active Member
  • **
  • Posts: 7
  • Country: us
  • Gender: Female
Stratus/Revit/Ductmate Frames
« on: Feb 01, 2024, 19:33:41 PM »
Anyone using Loose Ductmate frames in Revit?
Wondering how they work in packages and assemblies when they are sent to Stratus.
Logged

Offline davidratx

  • Premier Member
  • *****
  • Posts: 1408
  • Country: us
  • Gender: Male
Re: Stratus/Revit/Ductmate Frames
« Reply #1 on: Feb 02, 2024, 01:07:29 AM »
I've not seen this but if the .itm loads into Revit then you should be good. Putting it in an assembly shouldn't have any effect on its behavior.
Logged
David Ronson
TDIndustries Director of Construction Technologies
Windows 10 - Revit - AutoCAD - CADmep - ESTmep - CAMduct - GTP Stratus
Pages: [1]   Go Up
« previous next »