Author Topic: CID for gored elbow with cleanout  (Read 498 times)

0 Members and 1 Guest are viewing this topic.

Offline tharelkinTopic starter

  • Active Member
  • **
  • Posts: 2
  • Country: ca
  • Gender: Male
CID for gored elbow with cleanout
« on: May 09, 2024, 23:11:49 PM »
Is there a CID that would work for this? Cleanout diameter is same size as the elbow. We have been drawing these separate and generating a flat pattern for the cleanout. If there is could you point me in the right direction.

Thanks,


Offline CAMeleon

  • Active Member
  • **
  • Posts: 16
  • Country: us
  • Gender: Male
Re: CID for gored elbow with cleanout
« Reply #1 on: May 10, 2024, 00:01:01 AM »
Try CID#1173. You'll have to tweak a few dims but I think it might get you close.
Garrett Tice

Offline VirtualPilot

  • Premier Member
  • *****
  • Posts: 6738
  • Country: us
  • Gender: Male
Re: CID for gored elbow with cleanout
« Reply #2 on: May 17, 2024, 14:06:48 PM »
Try and see if CID#327 will work for you
Santos Cedeno
Pre-Production Mgr - DIXIE Metal Products

Offline VirtualPilot

  • Premier Member
  • *****
  • Posts: 6738
  • Country: us
  • Gender: Male
Re: CID for gored elbow with cleanout
« Reply #3 on: May 17, 2024, 14:08:03 PM »
BTW, I have never seen this required on any application as cleanout, we have used them for duct attached to gore, what is it being used for? What kind of duct system?
Santos Cedeno
Pre-Production Mgr - DIXIE Metal Products

Offline tharelkinTopic starter

  • Active Member
  • **
  • Posts: 2
  • Country: ca
  • Gender: Male
Re: CID for gored elbow with cleanout
« Reply #4 on: May 24, 2024, 21:39:31 PM »
Dust collection for some type processing facility. Tried both those CID and couldn't get either to work the way our fab shop wants. Thanks for the recommendation though.
« Last Edit: May 24, 2024, 21:49:30 PM by tharelkin »