Author Topic: HETO Tap adjusting location when elbow placed after HETO  (Read 581 times)

0 Members and 1 Guest are viewing this topic.

Offline Shaun1119Topic starter

  • Active Member
  • **
  • Posts: 41
  • Country: us
  • Gender: Male
HETO Tap adjusting location when elbow placed after HETO
« on: May 15, 2024, 13:59:50 PM »
Issue with placing elbows on a HETO.

I have a rectangular duct line. say 12x12. Place a HETO on the side 8" round. It places it fine. But then I go to add a gored elbow after the HETO. It moves the HETO back down into the duct. As if its taking the length of the coupling required between the heto and the elbow and shifting the duct back. Please see the attached snapshots. Any ideas? This is not an issue in CAD. Only in revit.

Thanks
Shaun