Author Topic: eVolve Autosleeve issues with foundations  (Read 345 times)

0 Members and 1 Guest are viewing this topic.

Offline Tye AustinTopic starter

  • Full Member
  • ***
  • Posts: 72
  • Country: us
  • Gender: Male
eVolve Autosleeve issues with foundations
« on: Aug 15, 2024, 16:51:15 PM »
We've had a few projects that require that we sleeve through grade beams in the UG.  Most structural files have their grade beams in the Structural Foundations category but some have been in the Structural Framing category. In the autosleeve setup there are just  Floors, Walls and Structural Foundations as options to check.   Anyone know if there is a way to add Structural Framing?  We've been adding our own structural foundations to get the sleeves in but I can see wanting Structural Framing in there if a GC or SEOR wants a quick beam pen layout...

Thanks for the help.
Plumber / Pipefitter / Lead Detailer
Local 447

Make sure present you always takes care of future you so future present you doesn't think past you is a total jerk

Offline rjdonahue

  • Active Member
  • **
  • Posts: 14
  • Country: us
  • Gender: Male
Re: eVolve Autosleeve issues with foundations
« Reply #1 on: Nov 11, 2024, 15:27:11 PM »
I've talked with eVolve about this and they said they have it on their roadmap to add the Structural Framing and the Roofs category as well. But nothing yet. I don't see it in the 8.0 update either...

We place those families manually right now.
Steamfitters Local 449