Author Topic: Hanger Centerline Elevation Tag  (Read 173 times)

0 Members and 1 Guest are viewing this topic.

Offline PipeFabRobTopic starter

  • Active Member
  • **
  • Posts: 1
  • Country: us
  • Gender: Male
Hanger Centerline Elevation Tag
« on: Oct 07, 2024, 18:05:07 PM »
Is it possible to tag the "Middle Elevation" of Fab Hangers? We are currently using spot elevations and would much rather use a tag.


Offline Tye Austin

  • Full Member
  • ***
  • Posts: 67
  • Country: us
  • Gender: Male
Re: Hanger Centerline Elevation Tag
« Reply #1 on: Oct 09, 2024, 21:53:48 PM »
We just tag the pipe as well and then use the bottom of pipe hanger elevation in the ITM hanger for our hanger cutlists so they can sticker each hanger with the correct elevation.   I'd think you wouldn't want to pull a centerline elevation from the hanger if you could though, because sometimes the hanger size is oversized for the OD of the pipe and the "centerline" of a hanger may not match the centerline of the actual pipe sitting in the hanger.
Plumber / Pipefitter / Lead Detailer
Local 447

Make sure present you always takes care of future you so future present you doesn't think past you is a total jerk