Fabrication in Revit® > Fabrication in Revit® Wish List

Part Material

(1/1)

sephirothnk:
We should have the ability to change the part material of any piece regardless of whether another piece is connected on both ends or not

CAMeleon:
All Part Materials on the sheet metal side are linked to specifications.
If you have a spec applied - only materials within that specification can be applied to pieces.
Program will not prevent you from drawing 3 galv pieces, and changing 1 of them to SS if you have your specs set accordingly.

Update - I didn't notice you were in Revit - it was early and I hadn't read where you posted my apologies!

CraigFarish:

--- Quote from: sephirothnk on Oct 28, 2024, 21:06:32 PM ---We should have the ability to change the part material of any piece regardless of whether another piece is connected on both ends or not

--- End quote ---

I'm guessing you only want to be able to switch to a material that is valid for the spec?

From a behaviour perspective, what would you expect to happen if the spec calls for a different, incompatible connector, or a different std length?

Navigation

[0] Message Index