Fabrication CADmep™ > CADmep™ Worksheets & Reports

nest report not working on certain pipes

(1/1)

michaelc:
not sure if any of you have had this .  but i cant seem to have certain database pipe work in the nest report to (see attached pic )  i have the niron set to 20' default but it keeps compiling it into one pipe

Darren Young:
Where do you have it set to 20' default?

The Default ITM length isn't what's used for the Linear Nest Reports.
You need to set it in the Material/Spec.

At least, last I tried it a decade ago.

michaelc:
thanks Darren .  i got it to work correctly now . they was the only material that was set to 0.000 length .

Navigation

[0] Message Index