« previous next »
Pages: [1]   Go Down

Author Topic: Crash in 3D mode  (Read 6155 times)

0 Members and 1 Guest are viewing this topic.

Offline AdminTopic starter

  • Administrator
  • Premier Member
  • *****
  • Posts: 1434
  • Country: gb
  • Gender: Male
Crash in 3D mode
« on: Feb 04, 2004, 21:43:19 PM »
A major bug has been identified and is active in the latest release version of CADduct Solids. This can cause drawings to crash.
Details on http://www.xtracad.com/latest.php
Logged
I do NOT offer support to forum postings via email, IRC or any form of instant messaging network. If you want help, ask here!

Offline Andy Robins

  • Premier Member
  • *****
  • Posts: 2393
  • Country: gb
  • Gender: Male
Crash in 3D mode
« Reply #1 on: Feb 05, 2004, 09:03:46 AM »
The description of the Bug is not quite right, the crash only appears to occur if the drawing is saved in 3D shaded mode, or you switch to 3D shaded mode once the drawing is loaded, if you leave the drawing in 2D wire frame, you are fine.
Logged

Offline AdminTopic starter

  • Administrator
  • Premier Member
  • *****
  • Posts: 1434
  • Country: gb
  • Gender: Male
Crash in 3D mode
« Reply #2 on: Feb 05, 2004, 18:45:32 PM »
Quote from: Andy Robins
The description of the Bug is not quite right, the crash only appears to occur if the drawing is saved in 3D shaded mode, or you switch to 3D shaded mode once the drawing is loaded, if you leave the drawing in 2D wire frame, you are fine.

Apologies Andy. Page now updated to reflect this.
Logged
I do NOT offer support to forum postings via email, IRC or any form of instant messaging network. If you want help, ask here!
Pages: [1]   Go Up
« previous next »