« previous next »
Pages: [1]   Go Down

Author Topic: TDC Connector  (Read 402 times)

0 Members and 1 Guest are viewing this topic.

Offline Mtt849Topic starter

  • Active Member
  • **
  • Posts: 6
  • Country: us
  • Gender: Male
TDC Connector
« on: Nov 25, 2025, 18:13:19 PM »
How do i get my Pittsburg to have an angle if I add "straight" (roller allowance) to a TDC connector. It removes my seam for the desired str, but it squares my seam up again when I develop. :P
Logged

Offline pauldaniels

  • Active Member
  • **
  • Posts: 25
  • Country: ca
  • Gender: Male
Re: TDC Connector
« Reply #1 on: Jan 16, 2026, 17:41:40 PM »
I have the same problem as well. Have not found a solution other than manually drawing the required allowance in OPUS. Cumbersome.
Logged
Pages: [1]   Go Up
« previous next »