« previous next »
Pages: [1]   Go Down

Author Topic: Tags stopped showing start point  (Read 303 times)

0 Members and 1 Guest are viewing this topic.

Offline fadachingTopic starter

  • Full Member
  • ***
  • Posts: 114
  • Country: us
  • Gender: Male
Tags stopped showing start point
« on: Oct 30, 2025, 13:25:23 PM »
Sorry, Was not sure what to title this. We upgraded from an older version to 2026 and out tags changed how they show where the starting point it and now circles a seam as shown. Any way to change it back to where it just shows the circle where the burn starts? I included a picture of my nest print out that still shows the marks how we would like them. My guys are going crazy about this.
Logged

Offline ThatCadGuy

  • Active Member
  • **
  • Posts: 26
  • Country: us
  • Gender: Male
Re: Tags stopped showing start point
« Reply #1 on: Nov 03, 2025, 16:44:47 PM »
It's a setting in nest label. Right click on the sheet layout graphic from nest label layout and there is a box you have to check in the Properties sub-menu.
Logged
Pages: [1]   Go Up
« previous next »