« previous next »
Pages: [1]   Go Down

Author Topic: Round Fitting Big End Connection Node Location  (Read 163 times)

0 Members and 1 Guest are viewing this topic.

Offline Mtt849Topic starter

  • Active Member
  • **
  • Posts: 6
  • Country: us
  • Gender: Male
Round Fitting Big End Connection Node Location
« on: Nov 18, 2025, 20:28:15 PM »
I am new to CAMduct and i am trying to recreate a big end connector to slip over undersized fittings / taps. As you can see its not at the end. How do I move the node?
Logged

Offline PipeFitter72

  • Full Member
  • ***
  • Posts: 219
  • Country: us
  • Gender: Male
Re: Round Fitting Big End Connection Node Location
« Reply #1 on: Nov 19, 2025, 00:14:47 AM »
go to connector, edit, then breakpoints and adjust the snap offset. see attached
Logged
Union CADD Database Administrator

Offline Mtt849Topic starter

  • Active Member
  • **
  • Posts: 6
  • Country: us
  • Gender: Male
Re: Round Fitting Big End Connection Node Location
« Reply #2 on: Nov 19, 2025, 12:23:13 PM »
Thank You!
Logged
Pages: [1]   Go Up
« previous next »