Fabrication CADmep™ > CADmep™ Worksheets & Reports

Incorrect quantities on report

(1/1)

mstratton74:
Hello all...

I am having a problem with the reports that CADduct Generates, sometimes the quantity of a certain fitting will not be correct. Then I try the same fittings again and it works correctly. Its possible that AutoCAD 2004 is not selecting everything it is supposed to. I use the Lower right and drag the box to the upper left method of selecting the fittings that I need a report on. What could cause this problem and how do I go about fixing it? If you need the IRP file I can attach it later.

Thank you,
Marcus I. Stratton
Brice Mechanical Inc.

Navigation

[0] Message Index