Fabrication CADmep™ > CADmep™ Worksheets & Reports

Surface Area Report

(1/1)

tnbndr:
OK, either I am having a really bad brain hemmorhage or I am trying to do something that can't be done.
I built this report, see attached, to select a duct run and give the field the total area in square feet for their pressure testing. That way they don't have to do the math. However I cannot not get this report to pick up attenuators (silencers) CID519, cut type set to Equipment, Bought Out, and
Service type set to Rectangular duct but also tried setting the Service type to Equipment. Neither scenario worked. The report does pick up our elbow silencer, based on CID3, however, with identical settings. :x
Anyone see something that I am missing? All help greatly appreciated.

Dennis
:D

Andy Robins:
Dennis
There is no problem with the report itself picking up CID 519, the problem is that item does not have any AREA reported because its not a manufactiured part, hence no development.

is it surface area (thats what the AREA Print Object is) you need or volume?

tnbndr:
Andy:
Its surface area that I need.
I figured that was why it wouldn't report the attenuator. I will just add a piece of duct the size of the silencer when necessary.


Thanks for looking

Dennnis :)

Navigation

[0] Message Index