Fabrication CAMduct™ > CAMduct™ Wish List

Conical tee's and crosses

(1/1)

Rick Hillson:
would it be possible to have the inset dimension on the conical tee and cross patterns cid  812 and 891 be taken from the centerline of the branch instead of from the base of the angle.
 this would make it easier for field layout and ordering. the angle usually does not matter just the centerline location of the branch.

Andy Robins:
Rick
under the Item tab, check "Centreline Input"

mikegamet:
If you don't see the centerline option on the item tab,   menu > Takeoff > Customize... you can place it anywhere  in the item tab, with the dialog there.

Jabbster:
What exactly does this "Customize Main Takeoff" feature do? I've been checking it out, but I don't see any results.

Navigation

[0] Message Index

Go to full version