« previous next »
Pages: [1]   Go Down

Author Topic: 20' table set-up  (Read 2303 times)

0 Members and 1 Guest are viewing this topic.

Offline petecoTopic starter

  • Senior Member
  • ****
  • Posts: 405
  • Country: us
  • Gender: Male
20' table set-up
« on: Sep 29, 2008, 16:54:59 PM »
Somehow our machine settings got jacked and it won't allow us to burn oversize sheets, just our stock size. we have a D6 and a D11 controller, and the error message from the D11 is "Bad Arc Block #11". The D6 gives us a message that also relates to arcs.

Everything else works great, just not this. Any help would be appreciated.

Thanks,
Logged
I didn't touch it.

Offline tnbquilt

  • Premier Member
  • *****
  • Posts: 726
  • Country: us
  • Gender: Female
Re: 20' table set-up
« Reply #1 on: Sep 29, 2008, 17:37:55 PM »
Stabbing in the dark here, but in your installed machines, setup for the double table in the special features is the Allow Arc as first/last cut checked? It sounds like it could be related to your problem, but I've never had specific problem... yet.
Logged
Tammy Beaman BHW Sheet Metal Co.
Architecture 2011 - CADduct version 2.41.037

Offline petecoTopic starter

  • Senior Member
  • ****
  • Posts: 405
  • Country: us
  • Gender: Male
Re: 20' table set-up
« Reply #2 on: Oct 01, 2008, 22:06:42 PM »
That seems to have done the trick, thanks.
Logged
I didn't touch it.

Offline tnbquilt

  • Premier Member
  • *****
  • Posts: 726
  • Country: us
  • Gender: Female
Re: 20' table set-up
« Reply #3 on: Oct 02, 2008, 18:38:47 PM »
Sometimes it's good to stab in the dark. I was wondering aobut you yesterday, if that had worked or not.
Logged
Tammy Beaman BHW Sheet Metal Co.
Architecture 2011 - CADduct version 2.41.037

Offline mikegamet

  • Senior Member
  • ****
  • Posts: 265
  • Country: us
Re: 20' table set-up
« Reply #4 on: Oct 27, 2008, 16:40:03 PM »
tammy rocks
Logged
Pages: [1]   Go Up
« previous next »