Fabrication CADmep™ > CADmep™ Worksheets & Reports

Item Worksheet Builder

(1/1)

hmaier:
I have been digging around the documentation, but can't find any info on the "Item Worksheet Builder". We managed to create custom reports, but there are a few tweaks I would like to make for the next project. One item is the "Auto" dimension. Any Item dimension defined as "Auto" also reports as "Auto", and I would like to get the actual length in the worksheet.

Andy Robins:
If you are using a 'filtered' worksheet, i.e. one worksheet for straights, a different one for bends, instead of using the 'Dimension List' object as is, you can use the Dimension List object for Dim1 and Dim2 and use Item Pattern Length object. This will print the real value.

Its a bit of a workaround, we will see if we can expand the Auto type values.

Navigation

[0] Message Index