Fabrication CADmep™ > CADmep™ Wish List

Cable Management Systems

(1/1)

gdury:
Dear Team

Has any provision been made to include underfloor amd overhead power track systems
within future release's of CADduct Solids.
For example; Ackermann
Located @ www.ackermann.co.uk

Regards
Graham Dury

Admin:
Graham

I've downloaded the latest .pdf files from the site so we can see what's involved in creating these items. I'll speak to Andy to establish whether the existing patterns available are sufficient to create the items.
I'll post again when I have some info.  :)

Edit:
Had chance to look at these in detail and it's difficult to know to what degree you'd require these. CADduct Solids enables users to customise and add catalogue items themselves and, basically, if I needed to draw these items I'd just draw some lengths of duct with flexes linking them to boxes - but that's just because I wouldn't require anything further if I were using this system and wanting to portray it in 3D.
It would take quite some time and effort to make a range of components to cover this system and then you have to take into consideration the fact that there are many such systems with varying dimensions.
As a user I'm not sure I would use these items enough to justify spending the time producing them, but that's just my opinion, I don't know whether MAP intend to include them at some point in the future.

gdury:
Thanks for your reply, i guess it's upto the users to generate and post the items upon the swap shop for general use if required. The spectrum of components used within the building services industry is quite vast.... come on users upload your custom items, were all in the same boat!

Navigation

[0] Message Index