Fabrication CADmep™ > Designline

Hangers with design line

(1/3) > >>

jryckman:
When I use design line to draw piping my hangers will draw for 1/2" and 1" with 1" insulation but not 3/4" or 1-1/4" with the same insulation.  Its seems to miss the 1/4" increments.  What would cause this?  Isn't it supposed to oversize the hanger to meet the next value?

CaddMan22:
Jason
What version are you on ?

jryckman:
I am on version 186

Tstright:

--- Quote from: jryckman on Dec 14, 2009, 16:36:23 PM ---Isn't it supposed to oversize the hanger to meet the next value?
--- End quote ---

Is that hanger in your service?

jryckman:
Yeah.....it is in my service or else it would not draw for any of the pipe.  Still cannot figure out why it is doing this?

Navigation

[0] Message Index

[#] Next page

Go to full version