Fabrication CADmep™ > Designline

Connectors in Design line

(1/1)

watsonidis:
I am trying to set up design line.  I have set up a service with some button mapping in it, I told it to use pressure class +2.  When I draw square duct, it puts the straight pieces in as TDC connectors and the Fittings in at Standing S&D (which is correct).  How can I get the duct to pull it's connector information from the pressure class that is assigned to the service?

watsonidis:
oh nevermind, I had the connectors locked....

Navigation

[0] Message Index

Go to full version