« previous next »
Pages: 1 [2]   Go Down

Author Topic: Adjustable Elbow  (Read 8977 times)

0 Members and 1 Guest are viewing this topic.

Offline mgalicki

  • Active Member
  • **
  • Posts: 5
  • Country: us
  • Gender: Male
Re: Adjustable Elbow
« Reply #15 on: Aug 02, 2024, 14:49:38 PM »
I am looking for a way to make a specific bend of PIPE not DUCT. Is this possible in Fabricationcadmep?
Thanks
Logged

Offline mgalicki

  • Active Member
  • **
  • Posts: 5
  • Country: us
  • Gender: Male
Re: Adjustable Elbow
« Reply #16 on: Aug 02, 2024, 14:55:28 PM »
Just draw the centerline of the bend & that's the length, Also, I am seeking a way to do a specific bend of PIPE in FabricationCADMep, Is this possible?
Thanks
Logged
Pages: 1 [2]   Go Up
« previous next »