Fabrication CADmep™ > CADmep™ Wish List

Stiffeners

<< < (5/5)

cadbob:
See attached they change by size and length

rptjr:
I believe I have this working - creating multiple stiffener specs per wg and lenght. Some overlap but its easier to just create them all than try to figure what can be used twice.
Anyway - overall my issue was with breakpoints and not understanding what the dif was between span and length.
Thanks.

cnash:
I know this is quite old but is this still the method everyone is using for their stiffener setup?

cadbob:
I haven't changed my stiffener setup Chris. Been so long think I forgot how I did it! LOL

cnash:

--- Quote from: cadbob on Jul 19, 2022, 12:40:45 PM ---I haven't changed my stiffener setup Chris. Been so long think I forgot how I did it! LOL

--- End quote ---

Haha, I understand that.
I am currently going through and completely overhauling all of our ductwork. As I was doing so I realized there were some things we overlooked since we weren't too concerned with some of the items at the time. Now I am trying to make sure it's all actually right and it's causing a few bouts of headaches and heartburn.

Navigation

[0] Message Index

[*] Previous page