XtraCAD.com

Fabrication CAMduct™ => CAMduct™ Users => Topic started by: RickD on May 17, 2018, 16:34:57 PM

Title: Bullnose type connector
Post by: RickD on May 17, 2018, 16:34:57 PM
Is there a way in CAM to setup a connector that goes down 1" then out away from the fitting 1"? I have looked in the help file but they seem to have decided not to update CAM information. I also did a search here but all the posts are from way back and all graphics attached are not there any more. Any help would be greatly appreciated.
Title: Re: Bullnose type connector
Post by: bparrell on May 17, 2018, 16:59:45 PM
Follow the pic. The graphics will be bad. They never fixed it along with the overall length measurement. Set the draw type to stepdown
Title: Re: Bullnose type connector
Post by: RickD on May 17, 2018, 17:38:34 PM
Thanks! I was hoping for it to draw right but it will work.
Title: Re: Bullnose type connector
Post by: bparrell on May 17, 2018, 17:59:06 PM
It displays right one way but length is off. I choose the other. It's been awhile but I'm sure I described it in older post.
Title: Re: Bullnose type connector
Post by: ocdcad on May 17, 2018, 22:50:47 PM
We do it slightly different, length and graphic ok in CAD.
End draw type = Standard
Breakpoints:
A & B = 9999
C = 0
D = -1 or 0
E = -1
F = -1
G = 0