The number one site for CADmep™ ESTmep™ and CAMduct™ users...
including additional topics and discussions covering AutoCAD®, Navisworks®, Revit®, GTP Stratus, and much more
Started in 2003, XtraCAD.com was set up as a platform to aid users of the newly evolving range of 3D parametric modelling software utilities being developed by Micro Application Packages (MAP) from Blackpool, England.

Throughout the continual development of these applications, including the acquisition of MAP by Autodesk® in 2011 and subsequent rebranding, we have remained the first port of call for many users of all levels seeking assistance.

We are proud that Autodesk 'fully understand the importance of XtraCAD for the CADmep and Fabrication community' and acknowledge that we 'do a great service by maintaining this community and understand it is important for users'.

Join us now and become a part of the future of Building Services Coordination & BIM.

* Who's Online

  • Dot Guests: 117
  • Dot Spiders: 11
  • Dot Hidden: 0
  • Dot Users: 1
  • Dot Users Online:

* Board Stats

  • stats Total Members: 5870
  • stats Total Posts: 114193
  • stats Total Topics: 17428
  • stats Total Categories: 10
  • stats Total Boards: 37
  • stats Most Online: 3286
Registered on XtraCAD but account not yet approved?

After registering an email will have been sent to you. Please check ALL the email accounts that you submitted when registering to ensure that it is not in your spam box. We could be waiting for a response from you.
EU Law: By signing in to this site I agree that XtraCAD.com may set cookies on my browser.

clipNotch angle for seams on round fittings

Yesterday at 17:12:47 by Dean-o | Views: 18 | Comments: 0
Hello all. I have just been informed that we will be purchasing a gorelocker. I haven't dove too deep into this previously as I was under the impression that this might not happen very soon. I can pos...
Read More | Write Comment

xxSpiral Duct nesting Software Add-on to Minimize waste

Dec 05, 2025, 14:29:41 PM by dfiorini | Views: 188 | Comments: 7
Wondering if anyone has found a good solution for nesting spiral duct to minimize waste?
Read More | Write Comment

xxTrimble Fabshop Export Add In Error

Dec 03, 2025, 20:39:15 PM by cduncan11 | Views: 106 | Comments: 0
Has anyone experienced this issue and found a solution? When I try to install the Trimble Fabshop Export add in for CADmep I get an error that says I do not have CADmep installed. However, I currently...
Read More | Write Comment

xxMapprod populating

Nov 27, 2025, 14:00:39 PM by b.kata | Views: 245 | Comments: 3
Hi,

We are working with a database that doesn't have a prodinfo.map file set up. After looking through some topics on the forum, it seems to me that while populating the database, you shou...
Read More | Write Comment

topicsolvedMissing transition fitting notch on seam at straight/change of direction

Nov 25, 2025, 20:17:06 PM by Mtt849 | Views: 185 | Comments: 1
I cant seem to get a notch to populate on Pittsburg Male or female at locations of str/or change of direction. 
Read More | Write Comment
Pages: [1]

* Recent Topics

* Recent Posts

Additional Content