Recent Posts

1

Fabrication Parts in Revit® / Conduit Clamp CID# 838

« Last post by rjdonahue on Today at 16:54:51 »

Does anybody know if there is a way to get the conduit clamp type hanger from pattern 838 to host to riser piping in Revit? Or is this just a quirk with that specific type? It would be nice if it behaved like the slide (riser clamp) type. Any info would be appreciated, thanks!

2

CAMduct™ Users / Re: Stiffeners not showing up

« Last post by cadbyken on Today at 16:03:59 »

One of the many benefits to this is that our shop manager was thinking of using the internal rods to support very large ductwork from. We can't easily get hanger points since they do not show in the model.

3

CADmep™ Users / Re: Pattern 2155 insulation

« Last post by cadbyken on Today at 16:01:44 »

I just made the part and have the same issue. v2024

4

General Discussions / Re: Hanger Sizing

« Last post by cadbyken on Today at 15:50:20 »

Unbelievable... Recognizing that there are more than 28 options to the clevis hanger pattern is step 1. Noticing the scroll bar on the right hand side is step 2. Thank you for pointing out the obvious.... Insert "dumb*ss moment" here... HA! Thank you!

We have all been guilty of missing both steps. 

5

Fabrication Parts in Revit® / Re: Fabrication parts export properties to schudule

« Last post by cadbyken on Today at 15:48:06 »

One way to export the "hidden" parameters is to use the Reports function in the Revit Extension for MEP Fabrication. This is what we setup and used in AutoCAD before Revit. The command is CSVEXPORT

6

CADmep™ Users / Re: Logo

« Last post by cadbob on Today at 15:15:17 »

I even deleted the configurations and re-did them thinking it may trigger but nope no luck.

Strange!

7

CADmep™ Users / Re: Logo

« Last post by ksperop37 on Today at 15:13:18 »

I take that back.  We have two configurations that are behaving that way.  Their image is not displaying.  The others are behaving as normal though.

8

CADmep™ Users / Re: Logo

« Last post by cadbob on Today at 15:07:57 »

Right, agree but not issue. I had even check for pathing in the INI

Notice the CADmep as a example!

The middle one dont have one

and the CAD-CAM does same as CADmep one it dont display png on 2026

Weird huh

9

CADmep™ Users / Re: Logo

« Last post by ksperop37 on Today at 15:04:51 »

The only thing I can think of is there is not a file named "Config.png" that is in the same directory as your map.ini file.

10

CADmep™ Users / Re: Logo

« Last post by cadbob on Today at 15:01:33 »

Just the PNG Image
Pathing is all correct and good of course, I even thought maybe they changed extensions so tried BMP and GIF, no go! lol