XtraCAD.com

Fabrication CADmep™ => Designline => Topic started by: bknapton on Apr 06, 2021, 21:45:15 PM

Title: shoe tap on round
Post by: bknapton on Apr 06, 2021, 21:45:15 PM
Does anyone know of a CID that allows you to product list a shoe tap on round and get it to work with design line?  I've tried CID #871 with no luck yet.
Title: Re: shoe tap on round
Post by: Darren Young on Apr 06, 2021, 22:19:40 PM
Why won't this work?  Dumb question...I suppose if you knew that...you'd make it work. ;-)

But seems like it should it matter and this should work. Does it work if not product listed?
Title: Re: shoe tap on round
Post by: bknapton on Apr 07, 2021, 13:16:52 PM
It somewhat works.  So far it's only working when I have duct main set to same size as "pipe diameter" on fitting.
Do I need to add "pipe diameter" to product for each size we would use?  Seems like a lot.
Title: Re: shoe tap on round
Post by: cadbyken on Apr 07, 2021, 14:54:19 PM
It somewhat works.  So far it's only working when I have duct main set to same size as "pipe diameter" on fitting.
Do I need to add "pipe diameter" to product for each size we would use?  Seems like a lot.
Yes, you would need one for each pipe diameter.  Create the productlist in Excel to make the work easier if you like.  Then cut and paste.
Title: Re: shoe tap on round
Post by: bknapton on Apr 07, 2021, 15:40:22 PM
I product listed all the options and now it works great.
Thanks for the help!