XtraCAD.com
Bug Reports & Service Pack Updates => General Bug Reports => Topic started by: Darren Young on Apr 17, 2019, 13:03:31 PM
-
2020 Fabrication products have some installer issues if you use Network licensing or build Deployments.
Pathing in the SETUP.INI file points to the wrong location for the NLM.msi
Look for this line in the SETUP.INI file....
Third-Party Component Open Source EULAs:x64\en-US\Tools\NLM.msi
And change to this...
Third-Party Component Open Source EULAs:x86\AdskLicensing\NLM\x64\NLM.msi
Make a backup copy of your SETUP.INI's prior to making this change.
At some point I'd expect them to update the installer files so you may only want to mess with them if you encounter issues.
See attached ZIP for updated SETUP.INI files for CADmep, CAMduct and ESTmep.
-
Apparently this isn't the first time....
https://knowledge.autodesk.com/support/fabrication-products/troubleshooting/caas/sfdcarticles/sfdcarticles/Installation-The-copy-functions-cannot-be-used.html
-
Darren, Have you done a install yet? Curious on about the Fabrication Add In Tab.
-
I will before the end of the week. Was waiting for all the major components to be available which I have now.
-
Does anyone have the Revit Extension for Fabrication 2020 yet?
-
Nope. You can copy/edit the files for 2019 and they'll likely still work in 2020. They typically do. But when they release it for 2020, you'll want to update it as they included CSV exports now in the addin.
-
Confirmed works. But I removed waiting on 2020 Version