« previous next »
Pages: [1]   Go Down

Author Topic: CID#64 will not allow C3 connector change  (Read 1975 times)

0 Members and 1 Guest are viewing this topic.

Offline cvdemickTopic starter

  • Active Member
  • **
  • Posts: 44
  • Country: us
  • Gender: Male
CID#64 will not allow C3 connector change
« on: Jan 22, 2018, 21:11:32 PM »
Hello All,

I am trying to use CID#64 in Revit and I cannot change the C3 Connector to anything else than what is defined in my spec. Currently is set to TDC but I need to change it to a 1 inch Flange In for a grille. I can select the right connector but when hit apply it doesn't change the connector. This is Typical for S&D and all other connectors. Other Tap in's work fine in Revit and CID#64 works fine in AutoCAD. Has anyone else seen this issue or know how to resolve it?

Thanks,
Chad--
Logged

Offline craigjonnson

  • Senior Member
  • ****
  • Posts: 287
  • Country: au
  • Gender: Male
Re: CID#64 will not allow C3 connector change
« Reply #1 on: Jan 25, 2018, 06:05:56 AM »
If the connector is connected to another i.e 2 pieces of duct. You cannot change the connector. You will have to disconnect to change the connector type.
Logged
Pages: [1]   Go Up
« previous next »