« previous next »
Pages: [1]   Go Down

Author Topic: Ancillary Reports in Revit - Wrong Nut and Bolt Counts  (Read 3330 times)

0 Members and 1 Guest are viewing this topic.

Offline sheetmetalmanTopic starter

  • Full Member
  • ***
  • Posts: 140
  • Country: us
  • Gender: Male
Ancillary Reports in Revit - Wrong Nut and Bolt Counts
« on: Jun 07, 2021, 18:24:18 PM »
Anyone experiencing issues with ancillary reports, my nut/bolt/washer counts for trapeze ancillaries is doubled.

Just the Nuts bolts and washers, on unistrut, the unistrut value is correct, my clevis and swivel seem to be correct.

If I export an maj and import it into CAD the reported numbers are correct, I'm in 2020 Revit, and just tried 2021, same.

I guess I could do a filter and calculated value, but man why cant it just work.
Logged

Offline bitterfitter

  • Senior Member
  • ****
  • Posts: 451
  • Country: us
  • Gender: Male
Re: Ancillary Reports in Revit - Wrong Nut and Bolt Counts
« Reply #1 on: Jan 21, 2022, 19:53:11 PM »
Not sure if you found your issue yet.  I tried mine out here and it works as expected.  Correct counts on all the hanger types.
Logged
"If you think education is expensive, you should see what ignorance costs you"
Pages: [1]   Go Up
« previous next »