Author Topic: Adjust length only for warps  (Read 262 times)

0 Members and 1 Guest are viewing this topic.

Offline mstrangerTopic starter

  • Full Member
  • ***
  • Posts: 99
  • Country: gr
  • Gender: Male
Adjust length only for warps
« on: Aug 01, 2022, 07:34:26 AM »
Hi all , i have problem specific with CID#9 (rectangular radius offset).
When assembly item the warps is shorter than other side of the item. specially when i have big offset. Is there any way to control length only for warps?
On CID#4 (radius bend there is an option to adjust , but there is not on CID#9.