« previous next »
Pages: [1]   Go Down

Author Topic: Slow and Choppy when cutting in ITM hangers  (Read 2074 times)

0 Members and 1 Guest are viewing this topic.

Offline Tye AustinTopic starter

  • Full Member
  • ***
  • Posts: 89
  • Country: us
  • Gender: Male
Slow and Choppy when cutting in ITM hangers
« on: Jun 13, 2023, 20:39:54 PM »
I'm finding that cutting in hangers is pretty clunky. the hanger location seems to jump around a bit. it's slow and choppy and sometimes there is a delay between when the hanger is placed and then it pops in.  Has anyone found a way to speed this process up?
Logged
Plumber / Pipefitter / Lead Detailer
Local 447

Make sure present you always takes care of future you so future present you doesn't think past you is a total jerk

Offline chris4455

  • Senior Member
  • ****
  • Posts: 426
  • Country: us
  • Gender: Male
Re: Slow and Choppy when cutting in ITM hangers
« Reply #1 on: Jun 14, 2023, 05:24:36 AM »
Have you tried Virtual Mechanical?  This will let you setup hanger specs and place hangers automatically based on specs.
Logged
MEP 2010 2.40.036/052 /64 bit/ Vista

Offline Tye AustinTopic starter

  • Full Member
  • ***
  • Posts: 89
  • Country: us
  • Gender: Male
Re: Slow and Choppy when cutting in ITM hangers
« Reply #2 on: Jun 15, 2023, 18:05:49 PM »
Yes.  We have the autohanger set up.  I'm just talking about when you need to manually place hangers.
Logged
Plumber / Pipefitter / Lead Detailer
Local 447

Make sure present you always takes care of future you so future present you doesn't think past you is a total jerk
Pages: [1]   Go Up
« previous next »