« previous next »
Pages: [1]   Go Down

Author Topic: Revit View Copied as Dependent and assigned scope box issue (Rotating View)  (Read 1698 times)

0 Members and 1 Guest are viewing this topic.

Offline Shaun1119Topic starter

  • Active Member
  • **
  • Posts: 45
  • Country: us
  • Gender: Male
Revit View Copied as Dependent and assigned scope box issue (Rotating View)
« on: Oct 04, 2023, 13:25:23 PM »
I am in the process of setting up shop drawing views in revit from our working view. I copy as dependent (say level 1) and go through the steps of changing the name and then assigning the drawing a scope box. The issue is once i assign the scope box, it rotates the shop drawing with with scope box 180 degrees. Does anyone have any idea?  ??? ???

Thanks
Shaun
Logged

Offline chris4455

  • Senior Member
  • ****
  • Posts: 421
  • Country: us
  • Gender: Male
Re: Revit View Copied as Dependent and assigned scope box issue (Rotating View)
« Reply #1 on: Oct 05, 2023, 05:59:10 AM »
Did you try to rotate the scope box?  Is your working view in a rotated overall scope box?
Logged
MEP 2010 2.40.036/052 /64 bit/ Vista

Offline Shaun1119Topic starter

  • Active Member
  • **
  • Posts: 45
  • Country: us
  • Gender: Male
Re: Revit View Copied as Dependent and assigned scope box issue (Rotating View)
« Reply #2 on: Oct 05, 2023, 13:44:30 PM »
I could not rotate the scope box and the view is setup like project n/s/e/w normally is. I went in and deleted the scope boxes and made new scope boxes dragging from left to lower right to create the box. When setting up the drawing with the new scope box it worked. Never happened before, but I am also currently working in 2023, so maybe there was a change.

Thanks
Shaun
Logged
Pages: [1]   Go Up
« previous next »