...serving the BIM community since 2003
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Home
Forum
Login
Contact
Register
XtraCAD.com
»
Fabrication CAMduct™
»
CAMduct™ Users
»
TDC/TDF Fold Notch
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: TDC/TDF Fold Notch (Read 1026 times)
0 Members and 1 Guest are viewing this topic.
brbuck2
Active Member
Posts: 15
Country:
Gender:
TDC/TDF Fold Notch
«
on:
Feb 01, 2024, 13:57:18 PM »
Hi, so we are trying to set up typical tdf/tdc where the pittsburg is notched 2.5", the fold and 1/4" are 2", can anyone help get this fixed, right now I have 2.5 on pitts and fold, and 2" on 1/4, how can I get the fold to be also 2"
Logged
Jona
Senior Member
Posts: 268
Country:
Gender:
Re: TDC/TDF Fold Notch
«
Reply #1 on:
Feb 01, 2024, 14:48:33 PM »
Your turnover is what you need to form the connector, and then the straight is what will cut back the seam.
Logged
1 Like
brbuck2
likes this.
brbuck2
Active Member
Posts: 15
Country:
Gender:
Re: TDC/TDF Fold Notch
«
Reply #2 on:
Feb 01, 2024, 15:11:52 PM »
Thank You Jona, that did it.
Do you think its possible to also only get 2" on the 1/4" also or you get both Pittsburg and 1/4 same?
Logged
Jona
Senior Member
Posts: 268
Country:
Gender:
Re: TDC/TDF Fold Notch
«
Reply #3 on:
Feb 01, 2024, 21:23:40 PM »
You could try making the male and female notches in the notch setup different lengths. But I think that would require everything to be 4 piece.
Logged
brbuck2
Active Member
Posts: 15
Country:
Gender:
Re: TDC/TDF Fold Notch
«
Reply #4 on:
Feb 01, 2024, 21:56:57 PM »
Ok yeah 4 piece duct is no fun. That might come handy for a weird curb.
Thanks again.
Logged
ussmjohn
Active Member
Posts: 1
Country:
Gender:
Re: TDC/TDF Fold Notch
«
Reply #5 on:
Jan 10, 2025, 19:47:18 PM »
brbuck2,
I was wondering if you were able to achieve the 2 different notch depth for male vs female?
Logged
brbuck2
Active Member
Posts: 15
Country:
Gender:
Re: TDC/TDF Fold Notch
«
Reply #6 on:
Jan 13, 2025, 19:24:13 PM »
no, I could only do both Pitts and 1/4 same, but different for the bend- I did a normal 2" notch then added 3/8" of straight (turnover) to complete it.
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
XtraCAD.com
»
Fabrication CAMduct™
»
CAMduct™ Users
»
TDC/TDF Fold Notch