hole offset in square bend CID#3

[nacnud]

Hi,
   we use square bend CID#3, on our machines running 2022/23 Fabrication the holes behave as expected, if you open the same fitting on 2024/25 Fabrication whatever offset hole distance is entered the hole remains offset central from the C1 basepoint.

any ideas? fixes?

Thanks.

[Jona]

In 2025, (and probably 24), it looks like if option 19 on the options tab is set to C1 then inset and offset are both tied to the same axis, but if you switch option 19 to "C2 End" then it uses both x and y axes.

[nacnud]

In 2025, (and probably 24), it looks like if option 19 on the options tab is set to C1 then inset and offset are both tied to the same axis, but if you switch option 19 to "C2 End" then it uses both x and y axes.

thanks, its strange that it has changed, but if that is the work around we will give it a go.