Reload Config Causes Standard Buttons to Appear as Incompatible

[wwessels]

I have had this happen with a few different types of fittings and while ago with a Valve.
These parts are all pretty standard patterns. And if I load them into a new project they work fine.
We are in Revit 2023 I am using 23.1.50.23
We are using a Project Specific Profile.
And this is a Workshared Project on BIM360.
Anyone had Similar issues or know of a fix?

[craigjonnson]

Ive not had that happen. Ive had content that missed connectors and various things going on, all of which was linked to the "Obey Versioning for User Data" tick box.

I also shift-right-click "clear cache" and repeat "refresh buttons, " which usually flushes out any gremlins.

[madcad]

Did you version the ITM?
If so try the modified versions from backup and modify again with out versioning.

[wwessels]

In this case none of the ITMs were changed. We Just needed to add the buttons.

[madcad]

Mmm.
I hope you post up the root cause when you find out, i am intrigued.
I had an issue with ITM versioning stopping a config reloading. It appeared to reload without error but did not actually reload. Removed the ITM from service and it worked fine. Updated old ITM without versioning and all fine.

[Darren Young]

Any chance this issues has resurfaced?

https://www.darrenjyoung.com/2020/04/09/fix-revit-fabrication-parts-suddenly-become-invalid/

[wwessels]

It appears this issue has resurfaced. I tried the clear cache and refresh all buttons but there is still one pipe that is showing as incompatible. But it’s from a service that is no longer being used due to a spec change so not a big deal