...serving the BIM community since 2003
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Home
Forum
Login
Contact
Register
XtraCAD.com
»
Fabrication CAMduct™
»
CAMduct™ Users
»
Looking for the suitable VPL for a small table
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Looking for the suitable VPL for a small table (Read 234 times)
0 Members and 1 Guest are viewing this topic.
JL-wshvac
Full Member
Posts: 69
Country:
Gender:
Looking for the suitable VPL for a small table
«
on:
Dec 06, 2024, 05:49:43 AM »
Hello:
who here would know which post processor uses M07 = torch ON and M08 = torch OFF. The rests seems to be pretty generic codes. The Burny's and D6 processors don't cut because the M codes are little different.
This small table controller should be "StarFire SF-2100 or similar" with THC.
Below is just a small piece of code from the manufacturer:
G90
G92 X0.0 Y0.0
G20
G00 X-8.2944 Y10.5007
M07
G01 X-8.122 Y10.4056
G03 X-8.4827 Y11.0028 I-0.1804 J0.2986
G03 X-8.122 Y10.4056 I0.1804 J-0.2986
G01 X-8.1259 Y10.6025
M08
G00 X-7.6261 Y7.024
Thanks guys!
Logged
JL-wshvac
Full Member
Posts: 69
Country:
Gender:
Re: Looking for the suitable VPL for a small table
«
Reply #1 on:
Dec 08, 2024, 07:52:57 AM »
I copied the D6 processor to change it slightly into a custom NC. Got the StarFire working so far, I will see are there any other machine codes that needs to be remapped. Trying to look for the corner accel/ decel functions on this a.t.m.
Logged
2 Likes
Darren Young
and
PipeFitter72
like this.
Print
Pages: [
1
]
Go Up
« previous
next »
XtraCAD.com
»
Fabrication CAMduct™
»
CAMduct™ Users
»
Looking for the suitable VPL for a small table