Author Topic: Autonesting 2xl 5' joint edge nesting nests joints on opposite sides of a sheet  (Read 99 times)

0 Members and 1 Guest are viewing this topic.

Offline Bigg HossTopic starter

  • Active Member
  • **
  • Posts: 1
  • Country: us
  • Gender: Male
we have a coil fed 20' vicon plasma table and I need to cut out 1- 2xl 5' joint. With edge nesting applied CAMduct is nesting the 2 parts on opposite ends of the sheet. Is there a way to get these parts to nest next to eachother so I dont have 16' of cut metal in between them? like common cut line for insulation?