« previous next »
Pages: [1]   Go Down

Author Topic: double wall area  (Read 296 times)

0 Members and 1 Guest are viewing this topic.

Offline joseriosTopic starter

  • Full Member
  • ***
  • Posts: 75
  • Country: es
  • Gender: Male
double wall area
« on: May 01, 2025, 07:48:56 AM »
HI
Is there any way to get in a item report the area of one item and the area of the skin , in a double walled pattern?
Logged

Offline VirtualPilot

  • Premier Member
  • *****
  • Posts: 6802
  • Country: us
  • Gender: Male
Re: double wall area
« Reply #1 on: May 01, 2025, 16:16:37 PM »
I though AREA had in the options to select DUCT or SKIN, must be dreaming...

You could probably use the total weight of the SKIN Material and divide it by the Skin Material Weight per Sq-Ft...
Logged
Santos Cedeno
Pre-Production Mgr - DIXIE Metal Products

Offline CAMeleon

  • Active Member
  • **
  • Posts: 36
  • Country: us
  • Gender: Male
Re: double wall area
« Reply #2 on: May 01, 2025, 17:27:48 PM »
Look for Item Duct Area (with Allowances) this will give you the ability to set the print object to Duct or Skin.
I've added 2 Duct Area (with allowances) and set one to duct, 1 to skin.
Took off SW, Lined, and DW Piece and ran a quick report against it.
Logged
Garrett Tice

Offline joseriosTopic starter

  • Full Member
  • ***
  • Posts: 75
  • Country: es
  • Gender: Male
Re: double wall area
« Reply #3 on: May 06, 2025, 15:36:22 PM »
can you show the configuration with more detail
Logged
Pages: [1]   Go Up
« previous next »