« previous next »
Pages: [1]   Go Down

Author Topic: restricted rod sizes  (Read 935 times)

0 Members and 1 Guest are viewing this topic.

Offline michaelcTopic starter

  • Active Member
  • **
  • Posts: 30
  • Country: us
  • Gender: Male
restricted rod sizes
« on: Jun 11, 2025, 11:46:02 AM »
little help here .  i need to manually change some rod sizes the are supporting revit families but i seem to be restricted to
3 sizes in bearer rod kit .  any way to over ride this .  or create new kits which im not familiar with and not sure where to find them in support settings in cad 
Logged

Offline rjdonahue

  • Active Member
  • **
  • Posts: 25
  • Country: us
  • Gender: Male
Re: restricted rod sizes
« Reply #1 on: Jun 13, 2025, 17:50:29 PM »
You can make new ancillary kits by going to Database > Ancillaries > Type of Ancillary at the top > drop down to Ancillary Kits. I'd copy one of the kits you have and change the support rod size and rename.

FYI Revit will only show you kits in the drop down on your hanger if the kit has a support rod in its contents. Any other kits will not show.
Logged
Steamfitters Local 449

Offline michaelcTopic starter

  • Active Member
  • **
  • Posts: 30
  • Country: us
  • Gender: Male
Re: restricted rod sizes
« Reply #2 on: Jun 13, 2025, 18:51:53 PM »
Thanks for the reply
Logged
Pages: [1]   Go Up
« previous next »