Fabrication CADmep™ > CADmep™ Wish List

Adjustable Elbow

(1/4) > >>

mstratton74:
Is there a way to make one of the other elbow item work for an adjustable elbow? I can change the angle of the elbow I know but it also shortens the finished size... It sounds lie a real task figuring out the length on an adjustable elbow at a paticular angle... Can it be done?

bparrell:
There is a fitting in the libary i believe its cid 155.You can play with it,but as i remember from what Cj said it was a little troublesome.Maybe he can explain.I have not use it. I Just figured the set out as far as a offset.

Andy Robins:
If you are talking Round Ductwork, make a copy of CID#61, edit it and set the Option 14 "Leg Lengths" to Yes, now look at the dimensions tab, you enter centre line distances for the lengths. Easy.
Same for Pipework, CID#2523

bparrell:
Andy,i'll try this,but not sure if the outcome is what he's suggesting(or my take on it) as far as the gores being able to rotate against one another.

mstratton74:
Bob is on the right track. All of the gores should stay the same size and they would rotate to create any angel between 0 and 90 (for an adjustable 90 Elbow) Its not real imparative.. I can just fudge the lengths it with my straight pipe... Seems we run into a lot of problems with pre-cutting our spiral pipe anyway...

Thanks Guys...

Navigation

[0] Message Index

[#] Next page