FiveOJester
Active Member
From: Fresno, CA
Registered: 08-January-2010
Posts: 4
|
|
New to TSI and playing with the DWG underlay feature in Estimating. Have the following issues:
1. I've got a "Master" Xref I use for my AutoCAD drawings that contains 8 "sub-xrefs" from various projects we have done. When I try loading this "Master" xref I get the error message "Failed to imort dwf file". I can load each individual xref and they underlay fine. This leads me to problem #2.
2. When loading multiple Xrefs I have no control of where they are placed. The Xrefs I am loading all have the same 0,0 in AutoCad however when I load them in EST, it is picking a generic point in the middle of the file and loading that at the center. This makes nothing line up. I can manually move each one to get it close, but there should be a way to make these line up.
Any ideas as to why it won't load my "master" Xref?
Is there anyway to set the insertion point for xrefs so I could at least load my "sub" xrefs manually?
_______________________________________
Dave Wills
Strategic Mechanical, Inc.
|
|
| 05-February-2010 20:09:28 |
|
Jump to
|
Powered by PunBB
© Copyright 2002-2007 Rickard Andersson
|
|
