The number one site for CADmep ESTmep and CAMduct users...
including additional topics and discussions covering AutoCAD®, Navisworks®, Revit®, GTP Stratus, and much more
Started in 2003, XtraCAD.com was set up as a platform to aid users of the newly evolving range of 3D parametric modelling software utilities being developed by Micro Application Packages (MAP) from Blackpool, England.

Throughout the continual development of these applications, including the acquisition of MAP by Autodesk® in 2011 and subsequent rebranding, we have remained the first port of call for many users of all levels seeking assistance.

We are proud that Autodesk 'fully understand the importance of XtraCAD for the CADmep and Fabrication community' and acknowledge that we 'do a great service by maintaining this community and understand it is important for users'.

Join us now and become a part of the future of Building Services Coordination & BIM.

* Who's Online

  • Dot Guests: 12
  • Dot Spiders: 8
  • Dot Hidden: 0
  • Dot Users: 0
  • Dot Users Online:
  • user Google
  • user Bing (7)

* Board Stats

  • stats Total Members: 5406
  • stats Total Posts: 108245
  • stats Total Topics: 16311
  • stats Total Categories: 10
  • stats Total Boards: 36
  • stats Most Online: 859
Registered on XtraCAD but account not yet approved?

After registering an email will have been sent to you. Please check ALL the email accounts that you submitted when registering to ensure that it is not in your spam box. We could be waiting for a response from you.
EU Law: By signing in to this site I agree that XtraCAD.com may set cookies on my browser.

Yesterday at 09:27:45 PM by Cam-burger | Views: 12 | Comments: 0

Is there a way to keep full length duct (ran off the coil line) from sending the liner to a liner cutting table?   
Yesterday at 08:32:02 PM by cnash | Views: 29 | Comments: 4

Anyone Figured out a way to have the lengths variable dependent based on the size?

See screenshot example below.
Yesterday at 12:29:19 PM by mstranger | Views: 23 | Comments: 0

Hi all .On some CID s (802 for example)  when adding hole it creates an complete circle. On some other CID s , when add hole create 4 arcs to make the circle. When running the nc on the 4 arcs hole, t...
Yesterday at 04:14:43 AM by SunTadZ | Views: 26 | Comments: 0

Upgraded from 2016 CADmep to 2022 and all seems well except the Fill between 2 ends wont stretch the pipe. I see there is a setting for how the Fill command acts and is it check to stretch pipe. Any o...
May 14, 2021, 09:52:26 PM by Cam-burger | Views: 99 | Comments: 3

We just switched over from running vulcan to cut out liner and now we are using CAMduct to do it.  I am struggling with getting the allowances to grow on both the heel and throats of angled & radius r...
Pages: [1]

* Recent Posts

Re: Oval Reducer Lengths by DotNet
[Today at 03:07:01 AM]


Re: Oval Reducer Lengths by cadbyken
[Today at 02:48:27 AM]


Re: Oval Reducer Lengths by cadbyken
[Today at 02:45:39 AM]


Re: Oval Reducer Lengths by DotNet
[Today at 12:42:56 AM]


Full length insulated duct to cutting table by Cam-burger
[Yesterday at 09:27:45 PM]